Aviom A-16II - Manual (Page 34)

26 A-16ii P
ersonAl
M
ixer
U
ser
G
Uide
making changes as needed. Remember, volume and pan changes only affect the channel whose LED is lit
solid. Press the G
ROup
button again to exit Group Mode. Save the mix Preset.
One channel in a Group is always available for editing, indicated by a flashing LED; press any other channel in the Group
to change its pan or volume.
Removing Channels From a Group
When in the Group edit mode (the Group LED is flashing), changes can be made to the channels included
in existing Groups. To remove a channel from a Group, simply double-click the channel that you want to
remove. The flashing LED will go out. To add other channels to a Group, double-click them. When you have
double-clicked to remove all channels that were previously part of the Group you’re editing, the Group will
no longer exist. You need at least two channels to have a valid group.
Exit the Group edit mode by pressing the G
ROup
button again. The LED in the Group button will go out.
This saves your changes to the Group. Save the mix Preset tp retain the settings for recall later.
Some points to note about Groups:
Up to three Groups can be created per Preset. •
Groups are relative only to the Personal Mixer that they are created on. •
Groups you create on one Personal Mixer do not affect other Personal Mixers being used •
in a system.
Remember that although you have edited and saved changes to a Group, you must still save the Preset if
you want to recall the Preset with the new Group configuration intact.