Aviom Aviom16/o-Y1 - Manual (Page 18)

11 Y1 A-N
et
C
Ard
U
ser
G
Uide
Any combination of mono and stereo channels can be used.
Stereo Link
Mode
1 2 3 4 5 6 7 8 9 10
This example shows a configuration where channel pairs 3-4, 13-14, and 15-16 are set for stereo operation. (DIP switch
handles shown in black.)
Mode Select Switches
Positions 9 and 10 of the DIP switch are used for MY card mode selection. There are four possible switch
combinations; three operational modes and one test mode are provided.
The Y1 card is scanned during the Yamaha console boot-up procedure only. It is therefore important to
remember that mode changes should be made only while the console is off. If it is necessary to alter the
Y1 card operational mode after the console has been booted, a console restart will be required in order for
the mode change to be recognized.
MY16 Mode (default)
Set DIP switch 9 o
ff
and switch 10 o
N
.
Stereo Link
Mode
1 2 3 4 5 6 7 8 9 10
MY16 mode offers 16 channels at 48kHz.
MY16 mode offers 16-channel output at a 48kHz sample rate. MY16 mode is not compatible with the PM1D
console; it must be set for MY8 mode.
The Yamaha console user interface will recognize the Aviom Y1 card as a generic 16-channel MY expansion
card. Names in text fields referring to the expansion card will display with a generic name (such as “MY16”),
depending on the model and software version of the Yamaha console.
In most cases, MY16 mode should be selected as the default setting.