Aviom SB4 - Manual (Page 23)

A-Net Input Device
A-Net Input Device
A-Net Input Device
A-Net Output Device
A-Net Output Device
A-Net Output Device
A-Net Output Device
A-Net Input Device
A-Net Bridge
(front panel)
Each port of the System Bridge contains one I/O pair.
To complete the digital snake setup, connect the A-N
et
B
rIdge
ports on the two SB4 System Bridges with a
Cat-5e cable.
Digital Snake Configurations
The SB4 System Bridge can be used to create configurations including 64 x 0, 48 x 16, and 32 x 32 using
Pro16 I/O modules. To create other configurations, simply swap the position of any pair of modules. Note
that any compatible Pro16 input module (such as the AN-16/i-M, Y1 card for Yamaha consoles, or other
Pro16 compatible third-party console interface card) can be substituted for the A-Net input devices shown
in the examples above.
Remember that in a digital snake configuration an A-Net output connected to a particular port (1-16, 17-32,
33-48, or 49-64) on one side of the System Bridge pair will always connect to an A-Net input of a device
connected to the same-named port on the other side of the System Bridge.
16 SB4 S yStem
B
ridge
U
Ser
g
Uide