AYRE AX-5 - Manual (Page 15)

Tape Outputs/Basic Setup Mode
The left-hand button on the AX-5 activates two
functions—the tape outputs and the basic input
setup mode.
Tape Outputs
The tape outputs may be controlled either by the
left-hand button on the front panel, or from the
remote handset. Pressing the button activates the
tape outputs, and pressing it a second time will turn
them off. When the tape outputs are activated, the
red LED in the front-panel switch is illuminated.
Turn the tape outputs off unless they are
currently being used. This will completely
disconnect the auxiliary components from the
AX-5 (including the ground connection),
eliminating the possibility of undesired ground
loops or other interference.
Basic Setup Mode
While the AX-5 is in low-power consumption mode
(green LED illuminated), pressing and holding the
left-hand front-panel button for three seconds will
enter the unit into the basic setup (input naming
and activation) mode. Additional basic setup
information is available in the chapter “Setup and
Configuration”, while advanced setup information is
available in the chapter “Optimization and
Customization”.
13