AYRE AX-5 - Manual (Page 9)

Setup and
Configuration
Due to the large number of available inputs (six) on
the AX-5, activating only the desired inputs allows
for simpler operation of the unit.
If no inputs are activated, the amplifier
will automatically enter the setup mode
when AC power is applied. Only the active
inputs will be included in the list of available
source components.
Activating Inputs (Basic Setup Menu)
The desired inputs are activated simply by naming
them. When AC power is first applied to the unit,
the front panel will briefly display “
AX5 ” and “ FWX ”
in sequence, where “ FWX ” indicates “Firmware
Revision X”, where “X” is a letter from “A” to “Z”.
Assuming that none of the inputs have yet been
configured, the unit will then automatically enter
the setup mode and the front panel will display
“ SET UP ” briefly. Then it will display “ OFF 1 ”,
(meaning input 1 is “off”) to allow the naming
(activation) of the inputs.
7
AX5
FWX
OFF 1
SET UP