Cannon Instrument CT-2000 (Contant Temperature Bath) - Manual (Page 9)

7
CANNON ® CT-2000 Constant Temperature Bath
Revision 1.0g—February, 2012; CANNON ® Instrument Company
2139 High Tech Road • State College, PA 16803 • USA
rubber may have to be
trimmed slightly to allow the
ends of the rubber gasket to
meet with no gap when
placed around the rim.
4. Remove the large piece of
foam packing from the inside
of the cabinet. Also remove
the small piece of foam from
the float level, located on the
upper left-hand corner of the
inside of the cabinet.
5. Lower the glass jar into the
cabinet so it seats evenly on
the rubber support ring.
6. Unwrap the two glass
panels. Place the thinner of
the two pieces of glass in the
slot closest to the jar (see
Figure 7).
7. Place the wider (tempered)
piece of glass in the front
slot furthest away from the
jar. The middle slot is left
empty as a vapor barrier.
8. Replace the rear top cover.
Align the four holes, then
insert and tighten the screws.
9. Replace the front top cover. Line up the four holes, then insert and
tighten the screws.
10. To ensure that the gasket forms a tight seal with the top covers of the
bath, proceed as follows:
11. Loosen the IEC lock screw securing the AC power cord to the rear
panel of the electronics drawer. Then unplug all three cables (AC
power, rectangular Cinch connector and round Amp connector) from
the rear of the electronics drawer.
12. Pull out the electronics drawer using the handles provided on the
front of the unit. Press down or pull up on the plastic release bars on
either side of the drawer track to release the drawer, then pull the
drawer completely free of the unit and set it aside.
13. When the drawer is removed, locate the four ¼-20 set screws visible
at the top of the drawer opening underneath the bath.
Figure 6: Seating the gasket
Figure 7: Placing inner glass panel