Checkline BL2 - Manual (Page 10)

© Electromatic Equipment Co., Inc.
-10-
3. Plug the probe of your FLW tester straight into the
material. It is not allowed to load the measuring head
incorrect or drop it down!
4. Plug in the sensor cable into the socket of the BL2. Take
care of the correct position and fix it with the knurled nut.
5. Change the calibration curve: Press one time the
key
and then the or key. The name of the calibration
curve can be seen at the head of the display.
6. Now the display shows the water content. Left hand
the temperature is displayed.
7. To save the results in the save menu press the
( button). The storage was successful when the
number in front of the symbol increased. To reach the
store menu please press until the appears.
8. To name the saved results press the
button.
9. Remove the FLW tester straight with caution and clean the measuring head.
Risk of injury by measuring head!
Keep away from children!
11.0
CALIBRATION CURVES FLW TESTER
Calibration curve Material
Digit 3 For special product
Empty 3 Customer calibration made by Checkline Europe
Test block ! Only for testing the BL2 with the test block !
© Electromatic Equipment Co., Inc.
-19-
and the guarantee stamp. If those are broken, no claims for guarantee can be
made. In case of a faulty device, please contact Checkline Europe.