Checkline BL2 - Manual (Page 13)

© Electromatic Equipment Co., Inc.
-16-
20.0 PRINT SAVED DATA
(Only possible with humimeter USB interface module in combination with Schaller
thermo printer)
To print your saved data, connect the device to the printer
using the printer cable that was delivered with your device.
Carefully loose the protection cap on the humimeter BL2. At
first plug in the side of the connector with the close plastic
casing at the humimeter BL2. Then switch on the device.
Not till then the other side of the cable has to be plugged in
at the printer. Switch on the printer by pressing
. Now the
green LED is blinking. If it does not blink, please change the
batteries and try again.
Press the button at your humimeter until you reach the
menu (see image on the right). Choose „Print Logs“ and
confirm by pressing
.
Now you can select if you want to print the last saved
measuring series or all saved measuring series (logs).
Confirm by pressing
again. The selected logs are printed
out now.
To save paper, please think of clearing the data storage
regularly.
© Electromatic Equipment Co., Inc.
-13-
14.0 RUNNING THE INSTRUMENT
Switch on:
Press the key for three seconds
Set the clock:
Press three times the key -> Options -> Date/Time
Save measuring value:
Save the measuring value by pressing the button below
the
symbol. The storage was successful when the
number in front of the symbol increased. To name the
saved results press the button.
Hold measuring value:
At first activate the function in the menu Options ->
Datalog time by choosing “Hold”. Then press the left key
until
appears. Press the key. The measuring value
remains on the display until another button is pressed.
Display lighting:
Press the key; Backlight will turn off automatically
after 30 seconds. Backlight will be activated by pressing
any key.
Power off:
Press the key for five seconds; the device will be
switched off when you leave the key. The device also
switches off automatically when no key is pressed for
four minutes.
Measuring
range limit: If the measuring value is
blinking, the valid measuring
range is exceeded. In this case
the accuracy will be decreasing.
15.0
LIST OF CALIBRATION CURVES
Pressing the
or key in the measuring for at least three
seconds and a list with all available sorts will appear. Select
your sort by pressing
or and confirm it with the key.
The measurement will continue automatically.