Checkline PM4 - Manual (Page 3)

 Electromatic Equipment Co., Inc
-14-
18.0 WARRANTY
Electromatic Equipment Co., Inc. (Electromatic) warrants to the original purchaser
that this product is of merchantable quality and confirms in kind and quality with the
descriptions and specifications thereof. Product failure or malfunction arising out of
any defect in workmanship or material in the product existing at the time of delivery
thereof which manifests itself within one year from the sale of such product, shall be
remedied by repair or replacement of such product, at Electromatic’s option, except
where unauthorized repair, disassembly, tampering, abuse or misapplication has
taken place, as determined by Electromatic. All returns for warranty or non-warranty
repairs and/or replacement must be authorized by Electromatic, in advance, with all
repacking and shipping expenses to the address below to be borne by the
purchaser.
THE FOREGOING WARRANTY’S IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR
PURPOSE OR APPLICATION. ELECTROMATIC SHALL NOT BE RESPONSIBLE
NOR LIABLE FOR ANY CONSEQUENTIAL DAMAGE, OF ANY KIND OR
NATURE, RESULTING FROM THE USE OF SUPPLIED EQUIPMENT, WHETHER
SUCH DAMAGE OCCURS OR IS DISCOVERED BEFORE, UPON OR AFTER
REPLACEMENT OR REPAIR, AND WHETHER OR NOT SUCH DAMAGE IS
CAUSED BY MANUFACTURER’S OR SUPPLIER’S NEGLIGENCE WITHIN ONE
YEAR FROM INVOICE DATE.
Some State jurisdictions or States do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation may not apply to you.
The duration of any implied warranty, including, without limitation, fitness for any
particular purpose and merchantability with respect to this product, is limited to the
duration of the foregoing warranty. Some states do not allow limitations on how long
an implied warranty lasts but, not withstanding, this warranty, in the absence of such
limitations, shall extend for one year from the date of invoice.
Electromatic Equipment Co., Inc.
600 Oakland Ave. Cedarhurst, NY 11516 - USA
Tel: 1-800-645-7330 / Tel: 516-295-4300 / Fax: 516-295-4399
Every precaution has been taken in the preparation of this manual. Electromatic assumes no
responsibility for errors or omissions. Neither is any liability assumed for damages resulting
from the use of information contained herein. Any brand or product names mentioned herein
are used for identification purposes only, and are trademarks or registered trademarks of their
respective holders.
 Electromatic Equipment Co., Inc
-3-
100 %
×
−
=
Mn
Mt Mn
WG
2.0 SELECTION OF CALIBRATION CURVE
Due to the countless number of paper types there is no standardised allocation of
calibration curves. The different calibration curves refer to the different densities of
paper or paper rolls.
The list of calibration curves below shows suggestions for paper types.
To ensure the best accuracy of your measurement you have to carry out a
comparison measurement using your online moisture measuring system or by kiln-
drying (according to DIN 287) once.
1. Measure the water content of your paper (on the roll or the pile) using all
calibration curves that offer realistic results and write down the measuring
results of the different calibration curves.
2. Now please note the effective water content determined by your online
measurement system or carry out a reference measurement according to EN
ISO 287.
3. Compare the determined reference water content with the measuring results of
the different calibration curves. Use the calibration curve with the measuring
result nearest to the reference water content. Info: The name of the calibration
curve can be modified to your specific paper name!
3.0
DETERMINATION OF THE REFERENCE WATER CONTENT
The humimeter PM3 determines the water content, which means that it calculates
the moisture referred to the total mass (EN ISO 287):
Mn: Mass of the sample before drying
Mt: Mass of the dried sample
%WG: Calculated water content