Checkline P2 - Manual (Page 3)

ELECTROMATIC Equipment Co., Inc.
-14-
12.0 WARRANTY
ELECTROMATIC Equip’t Co., Inc. warrants to the original purchaser that this
product is of merchantable quality and confirms in kind and quality with the
descriptions and specifications thereof. Product failure or malfunction arising out
of any defect in workmanship or material in the product existing at the time of
delivery thereof which manifests itself within one year from the sale of such
product, shall be remedied by repair or replacement of such product, at
ELECTROMATIC Equip’t Co., Inc.’s option, except where unauthorized repair,
disassembly, tampering, abuse or misapplication has taken place, as determined
by ELECTROMATIC Equip’t Co., Inc.. All returns for warranty or non-warranty
repairs and/or replacement must be authorized by Checkline, in advance, with all
repacking and shipping expenses to the address below to be borne by the
purchaser.
THE FOREGOING WARRANTY’S IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR
PURPOSE OR APPLICATION. CHECKLINE SHALL NOT BE RESPONSIBLE
NOR LIABLE FOR ANY CONSEQUENTIAL DAMAGE, OF ANY KIND OR
NATURE, RESULTING FROM THE USE OF SUPPLIED EQUIPMENT,
WHETHER SUCH DAMAGE OCCURS OR IS DISCOVERED BEFORE, UPON
OR AFTER REPLACEMENT OR REPAIR, AND WHETHER OR NOT SUCH
DAMAGE IS CAUSED BY MANUFACTURER’S OR SUPPLIER’S NEGLIGENCE
WITHIN ONE YEAR FROM INVOICE DATE.
Some State jurisdictions or States do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation may not apply to
you. The duration of any implied warranty, including, without limitation, fitness for
any particular purpose and merchantability with respect to this product, is limited
to the duration of the foregoing warranty. Some states do not allow limitations on
how long an implied warranty lasts but, not withstanding, this warranty, in the
absence of such limitations, shall extend for one year from the date of invoice.
ELECTROMATIC Equipment Co., Inc
600 Oakland Ave
Cedarhurst, NY 11516
Every precaution has been taken in the preparation of this manual. ELECTROMATIC
Equipment Co., Inc. assumes no responsibility for errors or omissions. Neither is any
liability assumed for damages resulting from the use of information contained herein. Any
brand or product names mentioned herein are used for identification purposes only, and
are trademarks or registered trademarks of their respective holders.
ELECTROMATIC Equipment Co., Inc.
-3-
2.0 MEASURING PROCEDURE
Exact measuring results can best be achieved by adjusting the measuring
instrument to the respective product temperature. So you should store the device
near the object you wish to measure. A temperature difference of more than 5 °C
results in a falsified measured value. Adjust the switch by shifting it to the correct
position (refer to type of product). Turn on your measuring device and put it on
the product with suitable pressure or move it with constant pressure lengthwise
along the product roll to detect the wet streak.
Take care that you hold your measuring instrument with a moderate but sufficient
pressure on the product because the compressed density influences the
measuring result. Make sure that you always exert the same amount of pressure
since the density of the material increases when it is pressed tighter or softer; so
you could get different measuring results every time you measure the material.
The absolute density can immediately be seen on the LC-Display. Please note
that the bigger the supporting surface of the sensor, the more exact is the
measurement (refer to sketch). The device turns off automatically after 90
seconds or when the measuring range has been exceeded.
Firmly press the
instrument on the
pile in the middle
Paper piles must be at
least 2 cm thick,
leather piles at least 1
cm
incorrect
Press the instrument
only lengthwise on the
paper roll