ChemoMetec NC-100 - Manual (Page 12)

1 Installation
2
1.1 Installation of the NucleoView Package ver. 2.3 - Windows 7
2
When the computer has been turned on and is finished with the start -up process, insert
the USB Flash disk supported with the NucleoCounter to the computer. Let the computer
install the USB Flash disk and the open the DISK.
Figure 1 NucleoView Package v2.3 Installer located on the USB Flash disk
Activate the application “NucleoView Package v2.3 Installer” and allow (hit Yes) the
Installer program to make changes to the computer (see Figure 2 User Account Control)
Figure 2 User Account Control
The Installer will welcome you and you can now continue the installation in a very
controlled manor.
2
This description applies to Windows 7 only.