ChemoMetec NC-100 - Manual (Page 19)

2 Getting started with NucleoView TM
9
2 Getting started with NucleoView
TM
NucleoView allows the user to register the results of cell counts with the NucleoCounter
on a computer. This is useful when documentation of results and data is needed.
2.1 Launch NucleoView
TM
NucleoView can be activated through the Windows “Start” menu. First select “NucleoView
2.2” from the “Programs” submenu, and then select “NucleoView”.
When NucleoView is launched, both NucleoView and the NC Receiver appear on the task
bar. The NC Receiver is an application, which must be active when receiving data from the
NucleoCounter. NC Receiver is launched automatically when NucleoView is launched.
Data from NucleoCounter can only be transferred if the NC Receiver is active,
therefore it must not be closed.
2.2 Selection of program mode
When NucleoView is launched for the first time, the window shown in figure 11 appears.
Figure 11 This start-up window allows for selection of the appropriate program mode.
You shall now select “Data collection” mode
9
for your NucleoView installation in order to
get full access rights. Once this program mode has been selected (click it using the mouse)
NucleoView is ready for use.
9
Data collection is the normal mode when an instrument is connected.