COP-USA DVRC264-4CH_USB User Manual
Page 30
Digital Video Recorder User Manual
24
Fig 3.7 Record Setup
STEP2
Set Video quality, Frame rate, and Resolution.
STEP3
Have Audio checked if you input audio and want to record. Check Time stamp to record
STEP4
Enable recording function for cameras in Record option.
Notice: If have camera uncheck here, it will not record in any recording mode.
STEP5
Set Alarm record hold time. It is for post alarm recording.
STEP6
Enable Recycle. It covers old video once HDD full. If you have it unchecked, it will stop recording auto once
HDD full
STEP7
Click OK to finish
Notice: The higher the used storage of every hour, the higher the value of Video quality, Frame rate and Resolution.
This Unit supports pre-alarm recording. But no option to set the pre-alarm recording time, the default is 10 seconds
3.3.2 Manual Recording
Just press REC button on the front panel after quitting system setup. Press Stop button to stop recording.
Or press REC button on remote controller, click again to stop.