COP-USA DVRHPEG-8 - Manual (Page 36)

Digital Video Recorder User Manual
STEP4 Select alarm out and recording channels. It can trigger any alarm out and cameras to record once motion
detected.
STEP5
Enable or disable Buzzer on board. Select speed dome and enable preset or auto cruise. Press OK to save
STEP6 Set Hold time. It is the interval time between the two adjacent efficient motions. If a second motion is detected in
Hold time again, it is recognized as a continuous motion. If a second motion is detected after hold time, this motion and the
previous are recognized as two different motion events.
STEP7
Click OK to save settings
STEP8 Enter SCHEDULE configuration. Select Motion and relative cameras to set, referring to 3.3.3 Timer Recording.
Notice: About preset and auto cruise, users can only select one at same time.
The actual post- alarm record time equals Hold time in RECORD and Hold time in MOTION
3.3.5 Alarm Recording
This unit supports recording channels and PTZ linking after alarm.
STEP1 Enter ALARM configuration, see Fig 3.12 Sensor Alarm Setup. Select cameras
Fig 3.12 Sensor Alarm Setup
30