Cub Cadet Ex2900 - Manual (Page 110)

14-28
14. PERIODIC SERVICE
Ex2900 / 3200 Operator's Manual
4. Turn the transmission oil filter with the filter wrench to
remove.
5. Install a new transmission oil filter and turn clockwise
by hand. Tighten the filter with the filter wrench to a
torque of 28.9 lb•ft (4kgf•m).
(C) Transmission oil filter 35 micron
(D) Transmission oil filter 10 micron
NOTE:
●After hand-tightening, only tighten by 2/3 turn with the
filter wrench.
6. Loosen the three bolts, remove the transmission oil
strainer cover, and draw out the O-ring and
transmission oil strainer.
(E) Transmission oil strainer cover
(F) O-ring
(G) Transmission oil strainer
7. Clean the oil strainer with kerosene or diesel oil.
8. Insert the transmission oil strainer, insert the O-ring
sparingly coated with the transmission oil, and then
reinstall the transmission oil strainer cover.
9. Reinstall and tighten the transmission drain plug, and
final drive drain plugs.
10. Clean the area around the oil fill cap, then remove the
oil fill cap from the transmission housing.
(H) Dipstick
(I) Oil fill cap
11. Add approximately 5.4 US gal (20.3 L) of the
transmission oil.
12. Reinstall the oil fill cap.
13. Start and idle the engine to check for any leaks.
14. Shut down the engine. Correct any leakage before
operating the tractor.
15. Check the transmission oil level and add more as
necessary.
P3013747
(C)
(D)
3013766
(G) (F)
3013740
(E)
3013705
(H)
( I )