Storage, Safe practices for storage, Preparing the machine for storage – Cub Cadet Ex2900 User Manual
Page 126: Safe practices for storage -1, Preparing the machine for storage -1, Storage -1, Safe practices for storage warning
Ex2900 / 3200 Operator's Manual
16. STORAGE
Be careful to avoid injury:
●Remember that vapor from diesel fuel is explosive and flammable.
●The exhaust from the engine contains carbon monoxide that can
lead to carbon monoxide poisoning, possibly causing serious
illness or even death. To avoid the danger of poisoning from the
exhaust gas, NEVER run the engine in a closed building that is not
positively ventilated.
●NEVER wash the tractor while the engine is running.
●Run the engine as shortly as possible when moving the tractor into
and from the place of storage.
●When fuel is in the fuel tank, NEVER store the tractor in a building
where fuel vapor can come into contact with open flame or spark.
●Before storing the tractor indoors, allow the engine to cool off.
1. Preparing the Machine for Storage
If planning to store the tractor for a long period, follow the procedure
described below.
The procedure is intended to ensure that the tractor is readily prepared for
operation when it is removed from storage.
1. Repair any worn or damaged parts. Replace the parts as necessary.
Tighten any loose bolts and nuts.
2. Repair scratched or chipped metal surfaces to prevent rusting.
3. Remove grass clippings and debris from the tractor.
4. Clean below the deck and remove grass clippings and debris from
inside the chute and bagger.
5. Remove the ballast from the tractor.
6. Wash the tractor and apply wax to the metal and plastic surfaces.
7. Run the tractor for 5 minutes to dry the belts and pulleys.
8. Apply a light coat of clean engine oil to pivots and wear points to
prevent rusting.
9. Lubricate the grease fittings.
10. Check the tire pressure. Adjust the tire pressure slightly higher than
specified.
11. Change the engine oil and run the engine for about 5 minutes to
circulate the oil throughout the entire engine block and the internal
moving parts.
12. Lower any implement to the ground. Apply grease to
the exposed areas on the hydraulic cylinder piston
rods.
1. Safe Practices for Storage
WARNING