Cub Cadet MTD 70 Series User Manual
Cub Cadet Special machinery
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1: Introduction
- Chapter 2: Basic Troubleshooting
- Chapter 3: Air Intake system
- Chapter 4: The Fuel System and Governor
- Fuel Line
- Inspect the fuel lines
- Inspecting the fuel
- Test fuel for alcohol
- The fuel filter
- Fuel tank vent
- The fuel tank
- Evaporative (EVAP) emissions system
- Troubleshooting the EVAP system
- Roll over valve vent
- Charcoal canister
- Manual Choke
- Autochoke
- 1P61/1P65 Autochoke
- 1P70 Autochoke
- Temperature compensating auto choke
- Primer
- Carburetors
- Inspecting the carburetor:
- Disassembly and rebuilding the carburetor
- Governor
- Governor shaft
- Governor cup and the governor gear
- Chapter 5: Lubrication
- Chapter 6: Starter and Charging Systems
- Chapter 7: Ignition System
- Troubleshooting the ignition system
- Troubleshooting the stop switch
- To test the stop switch:
- About the spark plug
- Cleaning the spark plug
- Inspection of the spark plug
- Spark plug removal
- Ignition module
- Module removal
- Installing the module and setting the air gap
- Engine brake and stop switch (if equipped)
- Adjusting the brake assembly (if equipped)
- Flywheel
- Chapter 8: Exhaust
- Chapter 9: Cylinder Head
- Chapter 10: Crankshaft, piston and Connecting Rod
- Chapter 11: Failure Analysis