Cub Cadet MTD 90 Series User Manual
Professional shop manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1: Introduction
- Professional Service Manual Intent
- Safety
- Fasteners
- Assembly instructions
- Model and serial number
- Maintenance
- Air filter (summer engines)
- Oil type and capacity
- Changing the oil
- Fuel
- Fuel filters
- Valve lash
- Cleaning the engine
- General torque specifications
- Maintenance Chart
- Frequently used specifications
- Chapter 2: Basic Troubleshooting
- Chapter 3: Air Intake systems
- Chapter 4: The Fuel System and Governor
- Inspecting the fuel
- Test fuel for alcohol
- Fuel tank vent
- The fuel filter
- Inspect the fuel lines
- The fuel tank
- Evaporative (EVAP) emissions system
- Troubleshooting the EVAP System
- Charcoal canister
- Roll over valve
- Choke
- Primers (snow engines)
- Carburetors
- Inspecting the carburetor
- Disassembly and rebuilding of the carburetor
- Fuel shut-off valve
- Governor
- Governor arm
- Governor shaft
- Governor cup and the governor gear
- Governor adjustment
- Chapter 5: Lubrication
- Chapter 6: Starter and Charging Systems
- Chapter 7: Ignition System
- Troubleshooting the ignition system
- Stop switch
- Remote (ignition) stop switch (snow engines)
- Test for ignition that won’t turn off
- The module
- Module removal
- Installing the module and setting the air gap
- Flywheel
- About the spark plug
- Cleaning the spark plug
- Inspection of the spark plug
- Spark plug removal
- Chapter 8: Exhaust
- Chapter 9: Cylinder Head
- Chapter 10: Crankshaft, piston and Connecting Rod
- Chapter 11: Failure Analysis