Hangar 9 Piper Pawnee 40 ARF - Manual (Page 22)

22
 Step 4
Attach the fuselage strut brackets using four
4-40 x 1/2-inch socket head screws and four #4 washers.
The bracket will angle down and point toward the wing
when installed.
Note: Make sure to use threadlock on the
screws to prevent them from vibrating loose.
 Step 5
Slide the large and small wing tubes into the wing as
shown. The small tube will be at the rear of the wing, and
the large tube toward the front of the wing.
o Step 6
Slide the wing tubes into the fuselage. Guide the servo
leads for the aileron and flap servos into the opening in
the fuselage while positioning the wing.
o Step 7
Secure the wing to the fuselage using a 4-40 x 1/2-inch
socket head screw and a 3/32-inch hex wrench.
Section 3: Wing Attachment