Hardy Advantage Weigh Modules LPB - Manual (Page 10)

HI LPB SERIES LOAD POINT ASSEMBLY
Page 4
if you are shipping the vessel fully asssem-
bled on the load points.
Step 4. Save the two shortest machine screws, the
ones that fasten the shipping brackets to
the base plate. You will use these hex bolts
to install the ground strap. (See Fig. 1-4)
Step 5. Place one of the ground strap connectors
over the threaded hole in the base plate.
These are the ones that fastened the ship-
ping bracket to the base. (See Fig. 5)
FIG. 5: GROUND STRAP INSTALLED
Step 6. Install the hex bolt. Tighten with a box end
wrench.
Step 7. Place the other ground strap connector
over the threaded hole in the top plate.
Step 8. Install the other hex bolt. Tighten with a
box end wrench.
Step 9. In the illustration we show the ground
strap installed on the left side when facing
the front of the load point assembly. How-
ever, you can install the strap on either
side if necessary.
NOTE: Do not connect the ground strap to the base plate on
the right side and to the top plate on the left side or
vice versa. Crossing over will interfere with the load
cell performance.