Hardy Enviro Bench Scales - Manual (Page 8)

P
ROVIDING
S
OLUTIONS
I
N
:
Tension Control
Process Weighing
Vibration Monitoring
Local Field Service
9440 Carroll Park Dr. · Suite 150 · San Diego, CA 92121-5201· 858/278-2900 · 800/821-5831
Fax 858/278-6700 · Web www.hardyinst.com
Document Number: 0596-0320-01 Revision A
b. If selection b above (auto/manual)
i. Will automatically add weight to accumulator even if out of range
ii. Will require the print button pressed to send output from serial port
c. If selection c above (manual/auto)
i. Will require the Program/Enter button pressed to add weight to
accumulator
ii. Will automatically send output from serial port when weight is added to
the accumulator with the Program/Enter button
d. If selection d above (manual/manual)
i. Will require the Program/Enter button pressed to add weight to
accumulator
ii. Will require the print button pressed to send output from serial port
To enable the Accumulator, press and hold the Tare Button
Printing the Accumulator
1. To view the accumulator
a. Press the Over/Under/Next key momentarily (requires gross weight to be at zero)
b. Display will then alternate between number of weighments that were added to
accumulator and the accumulated weight
c. Press the Over/Under/Next key again to exit to normal weight again, or after 30
seconds, unit will return to normal mode.
2. To Print the accumulator
a. While viewing the accumulator
i. Press the print button
1. Display will show ALL Y/N
a. If select ALL Y
i. Unit will print each weighment that was added to
accumulator and the total accumulated value.
b. If select ALL N
i. Unit will print only the accumulated total.
2. Display will then show Clr Y/N
a. If select Clr Y and press Program/Enter
i. Unit will clear accumulator
b. If select Clr N and press Program/Enter
i. Unit will not clear accumulator