Hardy Enviro Bench Scales - Manual (Page 9)

P
ROVIDING
S
OLUTIONS
I
N
:
Tension Control
Process Weighing
Vibration Monitoring
Local Field Service
9440 Carroll Park Dr. · Suite 150 · San Diego, CA 92121-5201· 858/278-2900 · 800/821-5831
Fax 858/278-6700 · Web www.hardyinst.com
Document Number: 0596-0320-01 Revision A
3. To clear accumulator
a. While viewing the accumulator
i. Press the ZERO key
1. Unit will display Clr Y/N
a. If select Clr Y and press Program/Enter
i. Unit will clear accumulator
b. If select Clr N and press Program/Enter
i. Unit will not clear accumulator
NOTE: If you wish to change units of measure on the unit, accumulator must be cleared.
Peak Hold
1. To enable Peak Hold
a. Press and hold the Over/Under/Next button until displays CHEC
b. Momentarily press Over/Under/Next button to display HOLD
c. Press Program/Enter to display HOLD (Y or N)
i. Press Over/Under/Next button to toggle Y/N to Y.
ii. Press Program/Enter to accept to display CSaved
2. Press #1 key to place the unit into Peak Hold mode.
a. First three leds of under/accept/over sections will flash
b. Leds for #1,2,& 3 buttons will turn on.
c. Unit will now show peak weight.
3. Press #2 button to go out of peak mode without loosing peak value
4. Press #3 button to exit peak mode and clear peak value.