Intertape Polymer Group (IPG) TWA 1000-M - Manual (Page 27)

TWA 1000-M (U9701) UDM 9701
27
P
REVENTIVE
M
AINTENANCE
Cutter Blade Replacement
Figure 10-7
Figure 10-8
1. Remove the water bottle
2. Remove the brush pot assembly
3. Remove the upper guide plate
4. Remove the three 4mm countersink hex
screws with a 2.5 mm hex key. NOTE: Be
careful to retain the threaded back plate
behind the cutter blade as you remove the
screws.
5. Remove the cutter blade and threaded back
plate
6. Remove the two 4mm screws on the striker
plate with a 2.5mm hex key.
7. Remove the striker plate
8. Replace the cutter blade and striker plate
9. Replace the brush pot assembly, water
bottle and upper guide plate
Figure 10-9
Striker
Plate
Threaded
Back Plate
Cutter Blade
Striker Plate
Cutter Blade