Panasonic FV-13VKML3 - Manual (Page 9)

7. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. (Fig.5)
INSTALLATION I (JOIST MOUNTING -I ) CONTINUED
IMPORTANT:
Remove the tapes from louver and springs
before installation. As shown below:
FV-13VKML3
FV-08VKML3 FV-13VKSL3 FV-08VKSL3
FV-13VKL3 FV-08VKL3
Install fluorescent lamp and night lamp as below:
Light cover
® Remove screw ®
(M4X8)
Gloves
Fluorescent
lamp
Night lamp
CAUTION:
■ Before turn on the light, make sure the connector
at the correct position.
■ The claw of connector must latch the rib
completely. (Fig.6)
8. Insert the grille mounting spring on the wiring side
into the slot and insert the plug connector I into
the housing of the lighting unit. (Fig.6)
9. Insert the sensor unit into slot of the grille;
Fix the lead wire of sensor unit into the clasp
(1 position). (FV-13VKML3 and FV-08VKML3).(Fig.7)
10. Adjust high / low delay time preset switch and low
speed air volume preset switch (Fig.8).
Refer to switch indication on page 7. (FV-13VKML3,
FV-08VKML3, FV-13VKSL3 and FV-08VKSL3)
11. Insert another mounting spring into the slot as
shown and mount grille to fan body. (Fig.9)
CAUTION:
Mount grille carefully so that lead wire of sensor
unit and lighting unit is not pinched.
Ceiling...^
Mounting spring
Grille-^ 1 (^Gioves
r—r* Fig.9
PDF created with pdfFactory Pro trial version www. pdffactory. com