Acronova NB12 Series - Manual (Page 13)

Version 1.3 Operation Manual, Nimbie NB12
© 2011, Acronova Technology, Inc. 13
D
EVICE
I
NSTALLATION
Finding a Place for Nimbie
Nimbie should be placed on a fairly level surface, firm enough to
support the unit and discs. Always allow ample workspace for your
operation, with easy access to the blank and finished discs.
Do not expose the unit to direct sunlight or high humidity, as it may
cause the unit to malfunction.
If you desire, Nimbie can be placed on a raised block so there is ample
room to receive discs from the Finish Disc Slot. Please refer to the
“More Than 30 Discs in One Session” section for details.
Using the Detachable Legs
Nimbie is designed to work either with or
without detachable legs. Without the legs,
the Reject Disc Slot (recession) on Nimbie’s
base will hold up to 3 rejected discs.
If your application doesn’t involve rejected
discs or separating a group of discs from
others, you may use Nimbie without the
legs. It is, however, recommended to use
the legs when possible.
The legs will raise Nimbie providing
sufficient room to accommodate additional
rejected discs, as well as easier access to
them beneath the unit.
Attaching legs to Nimbie is simple. Inserting one leg after another on
Nimbie’s base, match the leg to Nimbie (A to A’) and gently snap the
leg into the receptacle (B to B’) until it is firmly attached.
To remove the legs, gently press the notch (N) and pull it outward from
the
receptacle (B’).
Nimbie Installation
Follow the steps below to complete Nimbie’s hardware installation:
1) Place Nimbie on level surface so that it stands firmly on its legs.
2) Place the spindle box that came with the unit in front of Nimbie.
Use the alignment pad to appropriately position the spindle box