Lights – Acura 2000 Integra Hatchback - Owner's Manual User Manual
Page 214
Advertising
Lights
2. Undo the seven cover fasteners by
pushing on the center of each
fastener's head until it pops in.
Remove the taillight cover panel.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
4. Try the tail/stoplights and back-up
light to verify which bulb needs
replacing. Remove the bulb by
turning it counterclockwise.
5. Install the new bulb in the socket.
Test it to make sure it works.
6. Reinstall the socket into the light
assembly.
7. Reinstall the tether anchor
hardware.
Make sure the toothed washer is
on the bottom of the bolt. Tighten
the bolt to:
16 lbf.ft (22 N.m , 2.2 kgf.m)
If a torque wrench was not used,
see your Acura dealer as soon as
possible to verify proper
installation.
CONTINUED
Maintenance
Main Menu
Table of Contents
Advertising