CDA CI931 - Manual (Page 19)

Programme Phases and Power Cuts
Programme Phases
s When the programme is running, the programme phase and the time
remaining will appear on the display (Figure 32).
s The active phases will appear successively at the top of the display as the
programme progresses (Figure 32). The time remaining until the end of
the programme will also appear on the display. It updates at regular
intervals, but not minute by minute.
s Any option button can be selected provided the wash phase in which it
takes effect has not been passed and when the programme accepts
the option.
s Pressing the delay timer button during washing will have no effect on the
wash programme.
s Pressing the Start/Pause button during the wash activates the
PAUSE function.
If the programme is changed on the selector dial during the washing
and drying process, the washing machine will go onto PAUSE status
and the programme will be cancelled.
If you need to add or remove a garment, press the Start/Pause button
and make sure that the water level is not above the door overflow
level and that the temperature inside is not high. Press the Start/
Pause button again to restart the wash from the same cycle phase it
had stopped at.
Power Cuts
s If there is a power cut, when the electricity comes back on the washing
machine will continue to run from where it left off (it has several hours of
memory).
Warnings and Advice
s Level the washing machine by adjusting the feet to reduce the noise
caused by spin-drying.
s Try to wash clothes of different sizes in the same wash programme to
favour the distribution of the clothes inside the drum during spin-drying.
s This model has a safety system for spin-drying that prevents spin
drying from being carried out if the distribution of the clothes inside
the drum is too concentrated. This prevents the appliance from vibrating
too much.
s If you find that the clothes are not properly wrung out, try spin-drying
them again after having distributed the clothes more evenly in the drum.
17
fig. 32