AERCO Innovation (G-13-1854 and above) - Manual (Page 121)

Innovation Water Heaters Installation, Operation & Maintenance Manual
APPENDIX A – INNOVATION MENU ITEM DESCRIPTIONS
OMM-0078_0J
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Page 121 of
196
GF-128
Phone: 800-526-0288
PRI: 11/22/2013
APPENDIX A – INNOVATION MENU ITEM DESCRIPTIONS
MENU LEVEL & OPTION DESCRIPTION
OPERATING MENU
Active Setpoint This is the setpoint temperature to which the control is set
when operating in the Constant Setpoint or Remote Setpoint
Mode. When in the Constant Setpoint Mode, this value is
equal to the Internal Setpoint setting in the Configuration
Menu. When in the Remote Setpoint Mode, this value is the
setpoint equivalent to the remote analog signal supplied to
the unit
Air Temp For monitoring purposes only
Outdoor Temp Displayed only if outdoor sensor is installed and enabled.
Valve Position In Desired input valve position. This would normally be the
same as the valve position shown on the bargraph when the
heater is operating.
Flame Strength Displays flame strength from 0% to 100%.
Run Cycles Displays the total number of run cycles from 0 to 999,999.
Run Hours Displays total run time of unit in hours from 0 to 9,999,999.
Fault Log Displays information on the last 20 faults (0 – 19).
SETUP MENU
Password Allows password to be entered.
Once the valid password (159) is entered, options in the
Setup, Configuration and Tuning Menus can be modified.
Language English only
Time Displays time from 12:00 am to 11:59 pm.
Date Displays dates from 01/01/00 to 12/31/99
Unit of Temp Permits selection of temperature displays in degrees
Fahrenheit (°F) or degrees Celsius (°C). (Default = °F)
Comm Address For RS-485 communications (0 to 127). Default address is 0.
RS-232 should have its own (programmable) password.
Baud Rate Allows communications Baud Rate to be set (2400 to 19.2K).
(Default = 9600)
Software Version Identifies the current software version of the control box (Ver
0.0 to Ver 9.9).