Agasio A622W - Manual (Page 51)

[email protected] Page | 50 713-893-4514
19. Hard Reset and Firmware Upgrades
If for any reason your camera stops functioning or is giving you errors, you can always “hard reset” the
camera. This will completely wipe the camera settings that have been set, including any wireless settings,
FTP settings, or Alarm Settings. The hard reset allows you to set the camera back to default factory
settings when you are not able to access the camera anymore.
Figure 19.1 – The bottom of an Agasio indoor model camera, the reset button is located on the
right
To perform a hard reset, take the end of a paper clip and push the button that is located at the bottom of
the camera (indoor cameras), hold this button down for 20
– 30 seconds. Leave the camera powered on
during this process. The camera will start to automatically pan and tilt which signifies that the hard reset
has completed successfully.
If you have an outdoor camera, the reset button is located on the external wiring, hold this button down
for 20
– 30 seconds and the camera should be reset automatically.