AirTurn DIGIT - Manual (Page 19)

19
sliding one inside the other’s channel. Due to impedance
issues on the FS-6, you may need a splitter cable to change
modes.
Changing Modes
The BT-105 comes set up by default to Mode 3 which will work
with most applications. To change the mode, you will need to
use the splitter cable provided with your unit (Dual FS-6 units
only). To change to Mode 1, insert the splitter into port 1/2,
(closest to the red power switch), on the BT-105. Then plug the
cable coming from the FS-6 into the white end of the splitter to
change to Mode 1, or the black end of the splitter for Mode 2.
For Modes 3 and 4, plug the splitter into port 3/4 of the BT-105
and use the white cable for Mode 3 and the black cable for
Mode 4.
Turn off the BT-105.
Hold down the A pedal. Turn on
the BT-105. As soon as you see
the BT-105 start to blink green,
release the A pedal and the
power switch. You will first see a red light blink, then a number
of green lights blinking that correspond to the mode number,
and then one green light blink. If you do not get that result, try
again. The timing is about 1 second before you must release
the power button and footswitch
.
See the BT-105 section for details on characters associated
with each mode.