ALTANA Micro-Gloss Manual - Manual (Page 36)

35
9. Memory
To save measurement values, you must activate the
Memory function before measuring or else select or
create a memory. Up to 999 measurements can be
stored. A fixed memory area is already created for
each geometry or combination (e.g. M60°). These
memory areas cannot be deleted. A total of 50
memory areas can be created.
The Memory function can be used for sample mode,
Statistics and Continuous measurements. The
layout of the memory is such that the measurement
mode and the standard can be changed within a
memory area, but not the geometry.
9.1 Memory
You can use this function to turn saving on or off. A
check mark indicates if the function has been
activated.
Turning on Memory automatically selects the area
in memory that is predefined for the currently set
geometry (for example M20°60°).
When you press operate to start a reading, you are
asked to enter a name for this memory.
9.2 Select memory
All available areas of memory are listed in this
menu, beginning with the one that is predefined.
The number of measurements saved for each area in
memory is shown on the right.
Select the appropriate memory area with the scroll
wheel and activate the selection by pressing mode.
This automatically turns on Save and switches the
geometry if necessary (if the selected memory area
is defined for other geometries than what was
previously set).
Memory