ALTANA Micro-Gloss Manual - Manual (Page 37)

36
9.3 Create memory
Users can set up their own memory areas with this
function. Select the required geometry before you
activate this function. Then you must enter the
name of a memory area. You can confirm the
suggested name directly with the operate button or
change it with the scroll wheel. After you confirm,
Save is automatically turned on.
9.4 Delete memory
This menu lists all memory areas that have been
created with the number of values stored in each
one.
Use the scroll wheel to move the mark to the
memory area you would like to delete and press the
wheel.
A menu appears in which you can decide whether
you would like to delete just the content of the
memory area or the entire memory area.
For pre-defined memory areas, you can only delete
the measurement values.
9.5 Display memory
You can transfer data that has been saved to a PC
via the interface. The values can also be shown in
the display at any time.
The “Display memory” function opens a menu in
which all memory areas that have been created are
listed. Select the desired area of memory with the
scroll wheel.
Memory