ALTANA Micro-TRI-Gloss μ - Manual (Page 26)

25
English
Continuous 10
You can use this function to perform
up to 99 measurements at an
adjustable measurement interval.
This is helpful when you are
covering large samples and you
want to evaluate the homogeneity
of the surface.
If you select this function, you will
first be asked to enter the time that
defines the interval. The longest
measurement interval possible is 9
seconds, the shortest 2. The interval
slightly increases when thickness
sensor is activated.
To start a continuous measurement,
press the operate button (a note in
the display also tells you this). If you
would like to exit the continuous
measurement, press mode.
To start the measurement, press
operate. The unit now performs
measurements up to 99 times at the
set interval. Measurement values
are shown in the display after each
measurement. You can interrupt the
continuous measurement by
pressing the operate button (hold it
down briefly). The number of
measurements, the mean value, the
minimum and the maximum appear
in the display. Press the operate
button to continue with the
continuous measurement. To end
the measurement, press mode.