Cobra Electronics CP-9125 - Manual (Page 5)

continued
5
Installation Installation
Quick Set-Up Guide
Note
The battery must be charged at
least 12 hours before use.
Replacement batteries are
available direct from Cobra.
See Accessories section on
page 44.
4
Quick Set-Up
Guide
Connect round connector into power jack on
base.
indicator on base will flash rapidly.
Connect power adapter in outlet. 2
3
Install Ni-Cad battery in the handset.
To remove the battery door, press and slide
downward.
Observe connection orientation, connect the
battery and replace the door. The indi-
cator will blink until the handset is placed in
the base and power is applied to the base.
1
Place handset on base so indicator lights.
indicator will stop flashing.
Raise antenna to vertical position.
4
5
Low Batt
In Use
Charge
In Use
CP9125manual(6.12) 10/20/98 11:38 AM Page 10