American Diagnostic Corporation (ADC) Advantage Ultra - Manual (Page 14)

8.1. Traffic Light Indicator (6023N
only)
The bars on the left hand edge of the
display show the range within which the
indicated blood pressure values lie.
Depending on the height of the bar, the
readout value is either within the normal
(green), borderline (yellow), or danger
(red) range. The classification is based
on standards adopted from the WHO
(World Health Organization). Refer to the
chart to the right for details of the
classification.
9. MEMORY FUNCTION
9.1. Recall and Storage of Measurements
At the end of a measurement, this monitor automatically stores each result with date and time.
This unit stores 99 memories for each of 2 users.
Viewing the Stored Values
With the unit off, press the «MEMORY»
button. The display first shows "3A", then
shows the average of all measurements
stored in the unit.
NOTE: Measurements for each user are
averaged and stored separately. Be certain that you are viewing the measurements for the
correct user (with no time and date shown).
Pressing the «MEMORY» button again displays the previous value. To view a particular
stored memory, press and hold the «MEMORY» button to scroll to that stored reading.
If an irregular heartbeat is detected, the symbol is displayed including the time and
the result of the measurement.
Further information
Measurements should not occur soon after each other; otherwise, the results will be
skewed. Wait for several minutes in a relaxed position, sitting or lying, before you repeat a
measurement.
9.2. Discontinuing a Measurement
If it is necessary to interrupt a blood pressure measurement for any reason (e.g.
the patient feels unwell), the «ON/OFF» button can be pressed at any time. The
device immediately lowers the cuff pressure automatically.
Note: ESH/ESC guidelines may vary
from those indicated. Consult your
physician for information relating to
guidelines in your region.
6
0
2
3
N
O
n
l
y
MR30: Value of the last measurement – MR29:
Value of the measurement before MR 30