American Diagnostic Corporation (ADC) Advantage Ultra User Manual
Page 8
5.4. Setting the Time and Date
This blood pressure monitor incorporates an integrated clock with date
display. The device will also store the date and time of each
measurement in its memory. After new batteries have been inserted,
the device will request the date and time to be reset.
To set the date, begin with the year. The 4 characters (2014) on the
1.
screen will blink. You can change the year by pressing the
«MEMORY» button. To confirm and set the year, press the «TIME»
button.
The device will automatically advance to the month. To change the
2.
month, use the «MEMORY» button. To confirm and set the month,
press the «TIME» button.
To set the day, hour, and minutes, use the same steps. Push the
3.
«MEMORY» button to change the display value. Press the «TIME»
button to confirm and set the value.
Once you have set the minutes and pressed the «TIME» button, the date
4.
and time are set and the time is displayed.
NOTE
If you want to change date and time, press and hold the «TIME» button down for approx.
•
5 seconds until the user icon flashes. Press the «TIME» button again, and then you
can enter the new values as described above.
A single press of the «MEMORY» button or «TIME» button advances one operation.
•
Holding the button down speeds up the procedure.
•
5.5. Select the User
This blood pressure monitor is designed to store 99 measurements for each of
two users. Before taking a measurement, be certain that the correct user has
been selected.
With the unit off, press and hold the «TIME» button until the user
a)
icon starts blinking.
Press the «MEMORY» button to toggle between users.
b)
Press the «ON/OFF» button to make your selection.
c)
5.6. Selecting Measurement Mode (6022N, 6023N only)
This instrument enables you to select either standard (single
measurement) or measurement averaging mode (automatic triple measurement).
To select Standard mode, push the switch on the side of the instrument towards
a)
position "1."
To select Averaging mode, push the switch toward position "3." Note
b)
the MAM Advantage™ Averaging mode icon will illuminate
on the display.
If you select 1, then only one measurement will be taken. If you select 3, the unit
will inflate and deflate three times resulting in one final average.
5.7. Using MAM Advantage™ Averaging Mode (6022N, 6023N only)
In MAM Advantage™ Averaging mode, three measurements are automatically taken
1.
in succession and the result then automatically analyzed and displayed. Because
6
0
2
2
N
6
0
2
3
N
O
n
l
y
1 3