American Diagnostic Corporation (ADC) Adstation 5610 - Manual (Page 3)

Diagnostix™ Adstation™ devices.
Warning: Do not use batteries, electrical cords other than those included with this
product or replacement parts supplied by the manufacturer.
Warning: This product may contain a chemical known to the state of California to
cause cancer, birth defects, or other reproductive harm.
Caution: The standard material used is latex-free.
Attention: Some wall systems may include up to 3 additional extension modules.
Take care that the connecting cable does not get caught behind the extension
module. Push the connecting cable into the groove provided on the reverse side of
the extension module.
4. ATTACHMENT
a.) Wall Mounting
If mounting to the wall, use enclosed mounting template.
b.) Attaching the Wall Mounting Plates
If mounting to wall studs, use wood screws only. If mounting between studs, use the
enclosed mollies.
Take the wall mounting plate and hold it onto the wall so that the screws can be
pushed through the holes of the mounting plate into the mollies.
Screw in the screws with a screwdriver, as far as they will go.
If the optional wallboard is purchased, the mounting plates come pre-attached.
c.) Attachment of the ADC ® Diagnostix™ Adstation™
When all screws have been screwed in tightly, take the ADC ® Diagnostix™
Adstation™ and guide the screw heads through the openings (1). Then press the
ADC
® Diagnostix™ Adstation™ downwards until it snaps into place. (See illustration
on page 7).
d.) Attachment of the Extension Module (If Included)
In order to add additional extension modules, they must be electrically joined with
the transformer station before mounting it on the wall.
Using the enclosed module connection cable, plug one side of the connector into the
socket on the transformer module located on the right side transformer panel.
Plug the opposite end into the extension module contact, located on the left side
panel.
CAUTION: Make sure when plugging the connecting cable, that the 4 contacts of
the socket strip are postivily connected to the 4 contacts of the pin strip.