American Diagnostic Corporation (ADC) Adstation 5610 - Manual (Page 4)

Tuck excess wiring into each
extension to ensure a close side-
by-side fit to each extension
module.
Take the extension module and
guide the screw heads through the openings (1). Then press the extension module
downwards. (See illustration).
Attention:
Take care that the connecting
cable does not get caught
behind the extension module.
Push the connecting cable into
the groove provided on the
reverse side of the extension
module.
Repeat for any additional
extension modules (up to 3)
you may have purchased.
5. OPERATION AND
FUNCTION:
Plug device into electrical
outlet. Move the handle (5)
upwards out of the cradle (7)
and attach the desired
instrument head by placing it
with the two projecting guide
cams onto the handle. Press
the instrument head lightly
onto the handle and turn the
handle in a clockwise direction
until it stops. Removal of the
instrument head is carried out
by turning in a counter-clockwise direction.
6. LOCKING INSTRUMENT HEADS:
Instrument heads are equipped with a security feature. Use enclosed allen key to lock
head onto power handle. To secure, insert hex key into slot on head and tighten by
turning clockwise. Do not over-tighten. Keep the hex key in a convenient place in
case the head must be removed for cleaning or service.
7. SWITCHING ON AND OFF:
Switch on the wall system by using the rocker switch (3). The green control lamp (4)
1. 2. 3.