Clarity 420 - Manual (Page 13)

7. Press UP (
▲
) or DOWN (
▼
) to change
the hour digits.
8. Press CALL once to select. After the hour
digits are set, the minute digits flash.
9. Press UP (
▲
) or DOWN (
▼
) to change
the minute digits.
10. Press CALL once to select. After the
minute digits are set, AM/PM will flash.
11. Press UP (
▲
) or DOWN (
▼
) to for either
AM or PM.
12. Press CALL once to select. After AM or
PM is selected, the time/date digits
will be blank.
13. Press CALL once to display the time/date
again or press UP (
▲
) or DOWN (
▼
) to
go to the next menu.
Setting Contrast
Default: Level 2
1. Press CALL once to enter the Contrast
Level selection mode. The current
selected level flashes.
2. Press UP (
▲
) or DOWN (
▼
) to
change the level.
3. Press CALL to select level desired.
4. Press UP (
▲
) or DOWN (
▼
) to
advance to the next menu.
Clarity Power Technology
With the Clarity Power feature, the high fre-
quency sounds are amplified more than the
low frequency sounds so words are not just
louder, but clearer and easier to understand.
BOOST Clarity Power On/Off
The C420 has a BOOST CLARITY POWER
button that controls the loudness of the
receiver. Once the BOOST button is pressed,
an extra level of amplification is added over
the entire range of the volume control.
The TALK button will light ORANGE to indi-
cate the CLARITY POWER feature is activated.
WARNING: When the TALK button is lit
ORANGE volume may be at a high level. To
protect hearing, lower the volume control to
minimum before using.
Volume Control
The dial controls the level of volume the hand-
set and headset receive. The volume dial
provides up to 15 dB of volume before the
CLARITY POWER button is activated. Once
the CLARITY POWER button is pressed, the
Clarity 420 will provide up to 30 dB of gain.
Handset Ringer
Set the switch marked Ringer On/Off located
on the side of the handset. The ringer switch
must be set to ON for the handset to ring.
Feature Set-up
13
E
N
G
L
I
S
H