Clarity 420 - Manual (Page 9)

6. Set the TONE/PULSE switch located
on the back of the base to correct
dialing mode. Please check with your
local Phone Company if uncertain of
the type of service.
7. Place handset in the cradle to begin
initial charging.
WALL MOUNTING INSTRUCTIONS
The base unit may be mounted on a standard
wall plate.
1. With the back of the unit facing up insert
the supplied mounting bracket’s tabs into
the base’s lower tab slots in then direc-
tion of WALL MOUNT marked on the
bracket, then press down on the brackets
clips and insert them into the clip slots.
2. Plug one end of the supplied short
modular telephone line cord into the TEL
jack located on the back of the base of
the phone.
3. Insert the plug of the AC adapter into the
jack marked DC 9V 400mA located on
the back of the telephone base.
4. Route the adapter’s cord through the
narrow groove located on the back of
mounting bracket to secure the cord.
5. Plug the short modular telephone line
cord into the wall plate jack, then align
the mounting bracket’s keyhole slots with
the wall plate studs and slide the base of
the phone downward to secure it on
the wall.
6. Plug the adapter into a standard AC
power (electrical) outlet.
7. Press and lift out the handset holder tab,
turn it around so the narrow tab end
extends out and slide back into its slot.
This will hold the handset in the cradle
when the phone is wall mounted.
8. Lift the base’s antenna to a vertical
position.
9. Set the Tone/Pulse switch located on
the back of the base to correct dialing
mode. Please check with your local
Phone Company if uncertain of the type
of service.
10. Place handset in the cradle to begin
initial charging. Remember, you must
charge the phone for at least 12
hours before you use the phone for
the first time.
Note: Remember, you must charge the
phone for at least 12 hours before you
use the phone for the first time.
Getting Started
9
Diagram B: Wall mounting
E
N
G
L
I
S
H