AOC MW0812 - Manual (Page 54)

Note: When you use dynamic IP addresses, you do not have select “Use static IP
addresses” to configure the network settings.
3. After “IP settings”, go back to the Wi-Fi settings interface and tap the wireless
network you want to connect to. After the network connection is successfully
established, you can login to the network
to surf the Internet.
-49-
Checking status of wireless network
You can check the status of the c
connected
urrently
Wi-Fi through the following
ct is connected to the
n the
number of the bars lighting up)
nection interface, tap “Wi-Fi settings” and tap the currently
eed,
etwork settings, tap “Forget” in this window; if you
p “Wi-Fi settings”. The detected Wi-Fi
ks, press the M button and tap
other Wi-Fi network to connect to it.
listed in the detected network list,
methods:
· Status bar
After the produ
wireless network, the Wi-Fi indicator o
top of it lights up and the status bar shows
the Wi-Fi icon “ ” and signal strength (the .
· Wi-Fi network
In the network con
connected wireless network to show the information, such as name, status, sp
signal strength, and security.
ip: If you want to remove the n T
want to connect to this network, the settings above should be configured again.
Connecting to other Wi-Fi networks
1. In the network connection interface, ta
networks will be shown in the Wi-Fi network zone.
Tip: If you want to manually scan for available networ
“Scan”.
2. Tap an
Tip 1: If the network you want to connect to is not
Tap “Add Wi-Fi network,” enter the corresponding network settings, and tap “Save”.