AquaCraft Vela One Meter - Manual (Page 14)

14
PLEASE READ BEFORE RUNNING THE VELA SAILBOAT:
➧ NEVER attempt to swim after a stalled or stuck boat! Wait patiently
for the wind currents to return the boat to shore or use a tennis
ball attached to the end of a fi shing line to retrieve it.
➧ Sailing the Vela in winds over 15 mph is not advised.
➧ It is dangerous to operate any R/C vehicle when there is insuffi cient
light.
➧ CAUTION: Windy conditions cause rough water that will affect the
performance of your sailboat and increase the chances of taking
on water.
➧ Your Vela sailboat may occasionally take on small amounts of
water, especially when running in high winds or rough water, or
making tight turns. Keep a roll of paper towels handy and dry
out the hull interior after every run. Check for leaks if you notice
excessive amounts of water in the hull.
➧ IMPORTANT: If, for whatever reason, your boat takes on a large
amount of water causing the electronics to get wet, you must do
the following immediately: Remove the radio equipment from
the boat. Allow the components to air dry completely before
reassembling. Reinstall the components and check for proper
operation before running the boat in water.
➧ Total run time of the Vela sailboat is approximately 45-60 minutes
(assuming you begin with new batteries in the receiver box).
When you notice a decrease in power or sluggish response, it
means the batteries are nearly drained and it’s time to head for
shore. As soon as the boat reaches shore, turn off the power to
the receiver and transmitter (in that order).
MAINTENANCE
Make sure you replace low batteries. Leave the hatch covers off
overnight to allow any water to evaporate from the inside of the hull.
Clean the exterior of the hull with standard household cleaners and
check for any loose knots or screws.
NATIONAL ORGANIZATION
The American Model Yachting Association is a not-for-profi t
organization dedicated to promoting the designing, building, racing,
and preservation of all model sailing yachts, and membership is
open to all who are interested in these activities.
theamya.org
REPLACEMENT PARTS
To order replacement parts for the AquaCraft Vela use the stock
numbers in the list below. Replacement parts may be purchased
from your local hobby shop or by mail order. If you need help
locating a dealer, visit aquacraftmodels.com and click on “Where to
Buy”. If you are missing parts, contact AquaCraft Product Support
at:
Phone: 217.398.8970
Fax: 217.398.7721
E-mail: [email protected]
AQUB6403 Deck Guides and Rigging Cleats
AQUB6465 Hatch with Latches
AQUB6490 Jib Support with Tie Rod
AQUB7110 Sailboat
Stand
AQUB7500 Keel
AQUB7501 Keel and Bulb Thumb Nuts
AQUB7502 Keel Bulb with Weight
AQUB7825 Main Mast with Blocks
AQUB7826 Main and Jib Sail
AQUB7827 Mast
Head
AQUB7828 Main and Jib Boom with Blocks
AQUB8660 Rigging Line 12-Meters
AQUB8661 Rigging Line Adjuster Blocks
AQUB8662 Rigging Line Clips
AQUB8750 Rudder
AQUB8751 Rudder Control Arm
AQUB8802 Spreaders
AQUB8820 Sail
Clips