AquaCraft Vela One Meter - Manual (Page 6)

6
SAILBOAT ASSEMBLY
Assemble the rudder, grease and a 2.5mm hex wrench. Remove
both hatches from the deck by turning the winch drums 90°.
Very lightly grease the rudder post and slip it up into the
rudder stuffi ng tube located on the bottom of the boat. Align
the tiller arm so the rudder post is able to slide through.
Tighten the tiller arm screw using a 2.5 hex wrench. Make sure
you align the screw with the fl at spot on the rudder post.