AquaCraft Wildcat - Manual (Page 6)

6
IMPORTANT: If your boat takes on a large amount of water and stalls in the middle of the lake, don’t worry; your Wildcat EP has foam
fl otation so it will not sink. You will, however, have to retrieve the boat and remove the canopy to remove any water that might have
entered. If the inside of the boat is fl ooded, remove the transom plug from the back of the boat and allow the water to drain. Allow the
boat to fully dry before operating it again. Remember to re-install the transom plug before running your boat again.
MAINTENANCE
It is important to remove and re-lubricate the drive shaft after a day
of running. Make sure the battery pack is unplugged. To lubricate the
cable you will need a 1.5mm hex wrench, GrimRacer Cable Grease
and some paper towels.
Using a 1.5mm hex wrench, loosen the set screws holding the drive
cable to the motor coupler. It is important to note that there are two
set screws holding the cable in position.
Slip the drive shaft out of the back of the boat. Wipe off any grease
and water that might be on the shaft.
Using GrimRacer speed grease, apply a small amount to the shaft
and slide the cable back into the boat. Be careful to align the drive
shaft to the hole in the end of the motor coupler.
AQUB1810 Wildcat EP Mnl.indd 6 AQUB1810 Wildcat EP Mnl.indd 6 10/3/2011 2:04:54 PM 10/3/2011 2:04:54 PM