Artison Studio 39 - Manual (Page 4)

4
INSTALLATION OPTIONS
The Artison STUDIO SoundBar Speakers were designed to have multiple installation
options using the included hardware and brackets.
 Attachment to any Flat Panel TV (FPTV) in a Tablestand or Wall Mounted installation.
 On-Wall/Surface Mounting.
Please read the instructions below before attempting your installation.
INSTALLATION PROCEDURES
The Television Mounting Brackets were designed in compliance with the VESA Mounting
Standards. When using a third party FPTV wall-mount, the Television Mounting Brackets
are placed between the FPTV chassis and the FPTV wall-mount. In cases where the
display utilizes a table top stand, the Television Mounting Brackets can be attached
directly to the FPTV’s chassis.
REMOVAL OF FPTV CURRENTLY INSTALLED
1. If your FPTV is currently wall mounted, disconnect any wiring connections and remove
the FPTV from the wall mount. NOTE: This step may require two people.
2.
Place FPTV in safe location, display side down on a soft non-abrasive surface.
3.
Remove any existing mounting brackets and screws from the VESA mounting points
on the rear of the FPTV.
TELEVISION MOUNTING BRACKET PLACEMENT
4.
Position one Television Mounting Brackets across the left mounting points, one Thin
UMB across the right set of mounting points.
Align the flat inner return of the Television Mounting Brackets to extend beyond the
FPTV bezel by 1/8”, 1/4” if your FPTV is thicker than 1.8”. This will leave the required
space for the grille to fit between the FPTV and speaker cabinet, see FIGURE 1.
NOTE: If your television is too tall for the TMBs to align with both the upper and
lower set of mounting holes. Line up the TMBs with the closer mounting points
and use spacers on the other mounting points to keep the mounting brackets
parallel to the chassis.
5. The STUDIO SoundBar can be mounted on top or bottom of the FPTV. See
FIGURES 2 & 3 .