Avlink BX-3088 - Manual (Page 21)

BX Matrix Switching Systems—User Manual
20
Key LCD Display Operation
7. Press the NO.6 key of the
output cahnnel for 2 seconds and
then enter the input channel when
the red 0 on LCD begins to
flicker.
8. Press the NO.4 key of the input
channel for 2 seconds for
selection of the NO.4 channel for
input and the NO.1, 3, 5 and 6
channels for output. NO.1, 3 and
5 channels on LCD all show
“4”on IN row.
7.0 Matrix Application Software
7.0.1 Software Introduction
The 《AV Matrix》 Matrix control software applies to different input/output matrixes.
7.0.1.1 Software Description
The《AV Matrix》 matrix testing software is an application tool developed for matrix testing
and application. The software operation environment is as follows:
Window98/2000/NT/XP operatng systems
32M interal memory or above
10M hard disk space or above
CD-ROM
At least one serial communicatin port
7.0.1.2 Software Activation
First, you must turn off power both to the BX matrix and to the computer. Then, connect the
matrix RS-232 port to the PC RS-232 port using the bundled communication cable. (Refer to the
previous section “BX Matrix and Control Computer Connection.”;
Turn on power to the BX matrix and the computer:
Activate the AV Matrix.exe on the bundled CD-ROM in the control computer to enter the
control software interface.
7.0.2 Software Features
The software controls signal connection between the corresponding input port and output port
as required. The main operation window is shown in Figure 7-1 below: