Avlink PG-H1Z - Manual (Page 10)

10
1.6.3 PG-Y1Z (YPbPr_RCAx3)
Use for RCA cable connections. These connectors are
labeled Y, Pb and Pr. These are HDTV-Component video
connections to be connected to the Y, Pb and Pr connectors
of a HDTV monitor or TV with component video input.
ƒ Y connector: Y is for luminance signal drive a 1V
peak-to peak signal into a 75-ohm load. The Y signal can
be used alone in some cases, just like using luminance to
test only of an NTSC, PAL or SECAM TV with its
Composite input. The signal will be seen as a
monochrome image, which is fine for most patterns that
are monochrome.
ƒ Pb connector: Pb is for the chrominance (color) signal
drive 0.7V peak-to-peak signals into 75-ohm loads.
ƒ
Pr connector: Pr is for the chrominance (color) signal
drive 0.7V peak-to-peak signals into 75-ohm loads.
1.6.4 Power Jack
Use for the DC 9V power adapter. The Power Jack is on
the side of the device. The device supports 3 kinds of plugs
for choice (for USA, UK and Europe DC plugs.)
Power Jack