Buick 2010 Lucerne - Manual (Page 261)

Using the Re‐dial Command
1. Press and hold
b g
for two seconds. The system
responds with “Ready” followed by a tone.
2. After the tone, say “Re‐dial”. The system responds
with “Re‐dial using <phone name>” and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
. Press
b g
and begin speaking to answer the call.
. Press
c x
to ignore a call.
Call Waiting
Call waiting must be supported on the Bluetooth phone
and enabled by the wireless service carrier to work.
. Press
b g
to answer an incoming call when
another call is active. The original call is placed
on hold.
. Press
b g
again to return to the original call.
. To ignore the incoming call, continue with the
original call with no action.
. Press
c x
to disconnect the current call and
switch to the call on hold.
Three‐Way Calling
Three‐Way Calling must be supported on the Bluetooth
phone and enabled by the wireless service carrier
to work.
1. While on a call press b g
. The system responds
with “Ready” followed by a tone.
2. Say “Three‐way call”. The system responds with
“Three‐way call, please say dial or call”.
3. Use the dial or call command to dial the number of
the third party to be called.
4. Once the call is connected, press
b g
to link all
the callers together.
Ending a Call
Press
c x
to end a call.
4-101