Buick 2010 Enclave - Manual (Page 127)

Instruments and Controls 5-9
Clock
The vehicle has an analog clock
and a digital radio clock. The digital
radio clock can be enabled or
disabled.
Setting the Analog Clock
The analog clock is located on the
instrument panel above the radio.
The clock is not connected with any
other vehicle system and runs by
itself. To adjust the time:
1. Push and hold the button
located directly above the clock
to advance the clock hands.
Holding the button down causes
the clock to advance faster.
2. Push and release the button to
increase the time by one minute
increments.
Enabling/Disabling the Digital
Radio Clock
To enable or disable the radio clock
display:
1. Press
H
until the clock and date
setting menus appear.
2. Press the pushbutton located
under the forward arrow label
until the menu for default clock
and date settings appear.
3. Press the pushbutton located
under the currently displayed
status of either ON or OFF to
toggle the radio clock display on
or off. The ON display indicates
the radio clock display is
disabled and the OFF display
indicates the radio clock display
is enabled.
. If the radio clock display is
turned on, the screen
displays Radio Clock ON
for 10 seconds, then returns
to the original clock
display menu.
. If the radio clock display is
turned off, the screen
displays Radio Clock OFF
for 10 seconds. The menus
for clock and date settings
are removed, and ON
displays as a current status
indicating that the clock
display can be turned on.
If the radio clock and analog clock
are not synchronized. Use the
procedure below to synchronize
both clocks.
Setting the Digital Radio Clock
Adjusting the Time and Date
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN, then
press
O
, to turn the radio on.
2. Press
G
to display HR, MIN,
MM, DD, YYYY (hour, minute,
month, day, and year).