Rear vision camera (rvc), Rear vision, Camera (rvc) -36 – Buick 2010 Enclave User Manual

Page 280: 36 driving and operating

Advertising
background image

9-36

Driving and Operating

When the System Does Not
Seem to Work Properly

If the URPA system does not
activate due to a temporary
condition, the message PARK
ASSIST OFF displays on the DIC
when the shift lever is moved into
R (Reverse). This may occur under
the following conditions:

.

The driver disables the system.

.

The ultrasonic sensors are not
clean. Keep the vehicle's rear
bumper free of mud, dirt, snow,
ice and slush. For cleaning
instructions, see Exterior Care
on page 10‑87
.

.

A trailer was attached to the
vehicle, or a bicycle or an object
was hanging out of the liftgate
during the last drive cycle. Once
the attached object is removed,
URPA will return to normal
operation.

.

A tow bar is attached to the
vehicle.

.

The vehicle's bumper is
damaged. Take the vehicle to
your dealer/retailer to repair the
system.

.

Other conditions may affect
system performance, such as
vibrations from a jackhammer or
the compression of air brakes on
a very large truck.

If the system is still disabled, after
driving forward at least 25 km/h
(15 mph), take the vehicle to your
dealer/retailer.

Rear Vision
Camera (RVC)

The vehicle may have a Rear Vision
Camera system. Read this entire
section before using it.

{

WARNING

The Rear Vision Camera (RVC)
system does not replace driver
vision. RVC does not:

.

Detect objects that are
outside the camera's field of
view, below the bumper,
or underneath the vehicle.

.

Detect children, pedestrians,
bicyclists, or pets.

Do not back the vehicle by only
looking at the RVC screen, or use
the screen during longer, higher
speed backing maneuvers or
where there could be cross-traffic.

(Continued)

Advertising